PLEASE NOTE:
Before you begin, Make sure you have your Windows 95/98 CD-ROM or diskettes available and ready for installation.

Install Dial-Up Networking

1. Double-click My Computer on your desktop.
2. Double-click the Control Panel icon.
3. Double-click the Add/Remove Programs icon.
4. Click the Windows Setup tab.
5. Click the Communications component.
6. Click the Details... button.
7. Put a check in the box next to Dial-Up Networking .
8. Click the OK button.
9. Click the OK button again.
10. Windows 95/98 will prompt you for your installation diskettes or CD.
11. Wait for Dial-Up Networking to install.
12. When you are told to restart, click the OK button.
13. Click the Start button and choose Shut Down .
14. Select Restart the computer?
15. Click the Yes button.
16. Wait for Windows 95/98 to restart.

This may take a few minutes....

Add a Dial-up Adapter

1. Click the Start button point to Settings and choose Control Panel .
2. Click the Network icon.
3. Select the Configuration tab.
4. Click the Add button.
5. Select Adapter .
6. Click the Add button.
7. From the Manufactures: list, choose Microsoft .
8. From the Network Adapters: list, choose Dial-up Adapter .
9. Click the OK button.

Add TCP/IP

1. Click the Start button point to Settings and choose Control Panel .
2. Click the Network icon.
3. Select the Configuration tab.
4. Click the Add button.
5. Select Protocol .
6. Click the Add button.
7. From the Manufactures: list, choose Microsoft .
8. From the Network Protocol: list, choose TCP/IP .
9. Click the OK button.

Add Client for Microsoft Networks

1. Click the Add button.
2. Select Client .
3. Click the Add button.
4. From the Manufacturers: list, select Microsoft .
5. From the Network Clients: list, select Client for Microsoft Networks.

Create a New Dial-Up Networking Connection

1. Double-click the Dial-Up Networking folder
2. Double-click the Make Connection icon
3. Under Type a name for the computer you are dialing, type Access One
4. Double-click the My Computer icon
5. Click the Configure button.

• Check that you are using the appropriate port speed for your modem (for 14.4 modems use 19200 , for 28.8 modems use 38400 and for 33.6 and 56K modems, use 57600 .)
• Make sure that Only connect at this speed box is not checked.
• Click the OK button

• Click the next button

• In the Area code and Telephone number text boxes, type your local access number.
  Remember to check with your local phone provider to make sure that the number you choose is a local call.
• Click the Next button.

• Click the Finish button.

• Click the newly created Access One icon.
• From the menu bar, click File and select Properties .
• Click the Server Type Tab.

• For Type of Dial-Up Server , select PPP: Windows 95, Windows NT 3.5, Internet .
• Uncheck Log on to network .
• Check Enable software compression .
• Uncheck Require encrypted password .
• Uncheck NetBEUI .
• Uncheck IPX/SPX Compatible .
• Check TCP/IP .
• Click the TCP/IP Settings button.

• Select the Server assigned IP address button.
• Select the Server assigned name server addresses .
• Check both Use IP header compression and Use default gateway on remote network .
• Click the OK button.

• Click the OK button.

• Click the OK button.

• Click the OK button.

• Click the OK button to close the window.

Return to Accounts Page